Web Mountain Technologies RUC-01 User's Guide download pdf (Page 72)

Web Mountain Technologies Page 66

Now, you can start using Upstart as normal.

Running Remote Upstart over the Internet (WAN)

To setup running Upstart over the Internet (WAN), follow the same steps as above, except in

HW-VSP, rather than entering the local IP Address of the RUC, enter in the WAN IP address of

the network router used at the location where the RUC is installed. You can get this address

easily by merely typing in the URL line in your browser, www.ipchicken.com from any PC on

the LAN. Type this number in the HW-VSP text box for IP address. Other than this, perform

all of the other setup steps as above. You will probably have to open a port on your router

before you will be able to connect over the Internet. Please refer to your router documentation

for instructions on opening a port.

Once the PIM is connected, just use Upstart as normal.

UPB Interface Modules

There are UPB interface modules made by a number of different companies. Any UPB interface

module that can be connected to the DB9 on the RUC should work fine, however, there is one

issue that you should consider. In the normal Upstart mode, the PIM is put into Pulse mode,

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 103 104

No comments

Web Mountain Technologies RUC-01 User's Guide Page 72